null

TierraCast Luna Moth Necklace Tutorial

TierraCast Luna Moth Necklace Tutorial

Created by: Tracy Proctor of TierraCast


Designer Tips

  • String 8mm gemstone pebble bead and 1 gold spacer onto head pin. Bend wire over at top of spacer and use round nose pliers to form a 1/8" simple loop, trimming excess wire. New to jewelry-making? For step-by-step looping and stringing instructions, see Jewelry Basics 101 (PDF).
  • Open simple loop and attach at bottom of Luna Moth. Close loop. Set aside.
  • Use jump ring to attach luna moth to bail. String spacer and gemstone bead onto head pin and form large simple loop. Attach at bottom of luna moth pendant.
  • Open 1 jump ring and attach it to 1 Flora ring. Close jump ring. Repeat.
  • Cut one 10-12" piece of beading wire.
  • String on 1 crimp bead onto beading wire. Thread wire through 1 jump ring placed in Step 3. Thread end back through crimp bead and adjust so crimp bead is close to jump ring, leaving 1/2" tail. Use crimping pliers to secure. Trim tail close to crimp bead.
  • String beads in desired pattern, adding the pendant with bail in the middle, and repeat crimping step on other end. Tip: When securing final crimp bead be sure not to make the beaded strand too tight. Allow breathing room for the bail and for the strand to drape nicely.
  • String 1 barrel bead onto one end of the silk ribbon. Thread end through ring at one side of beaded strand, then back through barrel bead. Pull through a few inches, then form a sliding knot by tying working end around ribbon in an overhand knot, leaving a 1" tail. (Hint: Aim tail of ribbon towards back of necklace.) Repeat on other side of necklace.
  • To adjust length, move the sliding knots and adjust ribbon and barrel beads as desired. (Knots at the back of the necklace for a shorter necklace, knots close to Flora rings for a longer necklace.)

Suggested Supplies

Tools

Jul 31st 2021 TierraCast

Our Bead Blog