Tronex Oval Razor Flush Cutters Semi-Relief with Ergonomic Handle

Tronex oval head cutters make for an essential wire cutting tool. They are for general use. The ergonomic handles are 4.8 inches, fitting the average hand much better than the smaller tools on the market and allowing for easier repetitive use without fatigue. The Razor Flush edge has no bevel on either cutting edge. The back side is absolutely flat at an angle of 45 degrees to the plane of the cutting surfaces. The exceptionally sharp edges produce cuts with virtually no raised surface on the lead (under a loupe you can see a line on the lead where the edges come together but you will not see a pinch). Also, minimum shock is imparted to the cut lead or component. However, more frequent sharpening is required with a Razor Flush cutter. The Razor Flush edge finish on Tronex cutters is executed by a proprietary process and thus unmatched by any other precision cutting tool in the world. It is also the edge finish selected for almost all specialty cutters (tip cutters and angulated cutters) made by Tronex. Recommended for use on soft wire no larger than 18 gauge.