Rings & Things Jewelry Blog

Delicate-looking filigree bead caps give this memory-wire bracelet the crowning touch. Created by: Rita Hutchinson Designer TipsAdd bead caps to each end of (2) 8mm fine rocks tubes and string each on a headpin; trim and loop. For step-by-step looping instructions, see Jewelry Basics 101 (PDF).Add bead caps to each side of (2) crystal pearls and string each on a headpin; trim and loop.Lay out desired pattern on bead mat. The pattern here adds bead caps to each crystal pearl and to the …

Created by: Mollie ValenteDesigner TipsMix the adhesive according to the manufacturer's instructions.Apply masking tape to the back side of the filigrees. This will prevent the adhesive from leaking through the openings.Apply adhesive to the back side of the flat-back crystal and center it on the filigree. Press gently in place. Repeat with the second filigree and crystal.Set the pieces aside in a warm area to cure. Curing overnight is usually best.Once cured, remove the masking tape from the ba …

Created by: Rings & Things StaffDesigner TipsThis symmetrically designed necklace has a finished length of 17". For a different length, adjust the amount of beads, bead caps and stringing cable accordingly.The necklace pictured was made with large 10mm, 12mm and 14mm "shell" pearls, which are no longer available. Please note: 6, 8 and 10mm Swarovski pearls are now listed below. This will give you a more petite necklace. (The bead caps listed work great on 10mm and smaller beads.)Free Techniq …

Created by: Rita HutchinsonDesigner TipsDetermine desired length of finished bracelet.Subtract 1 1/4" from total desired length for connector piece.Keeping toggle clasp parts attached, remove center section of toggle chain bracelet leaving equal lengths of chain for either side of the bracelet. You do not have to cut the chain links. You can open them like a jump ring and use this chain section for another project.Attach the connecter to center section of chain and check fit before proceeding.Wi …

Designer TipsGently squeeze the prongs on the rhinestone chain ends to prevent chipping.Attach 5mm jump ring to one end. (See Jewelry-Making Basics for best way to open and close jump rings.)Use smaller jump ring to attach chain end to clasp at other end.Customize in brass or silver too!Free Technique Sheets & How-TosBasic Jewelry-Making Technique Sheet (PDF)Suggested Supplies1 pkg of 10 [use 2] #46-339-30-9 Chain End, for #46-349-30 (Black Gunmetal)1 meter [use 7.25"] #46-349-30-042-9 Gunme …