null

Rings & Things Jewelry Blog

Joyful Summer Vinyl Bead Jewelry

Joyful Summer Vinyl Bead Jewelry

Created by: Guest Designer Deb FlorosSuggested Supplies 1 #22-535-74 Trade Beads, Vinyl, Heishi, 6mm - Green (strand)1 #22-535-50 Trade Beads, Vinyl, Heishi, 3mm - Pink (strand)1 #22-535-63 Trade Beads, Vinyl, Heishi, 4mm - Yellow (strand)1 #24-939 Sterling Silver Bead, Open Spiral (Each)2 #05-000-08-16 PRESTIGE 5000 Faceted Round Beads, 8mm - Rose (Each)2 #26-750-39-AS TierraCast Large Shell Bead - Antiqued Silver Plated (Each)1 #34-580 Sterling Silver Leverback Ear Wire, "V" Design (pair)1 #6 …
Jun 21st 2024 Deb Floros
Arrow - Etched Copper Bracelet Tutorial

Arrow - Etched Copper Bracelet Tutorial

Created by: Summer MelaasDesigner TipsOptional: Punch a hole in the corner of the blank, following instructions in hole-punch below. After completing bracelet, dangle a charm or beaded dangle of your choice from the corner.Etch bracelet, using etching tutorial below. You can draw a design with Sharpie, or use your favorite rubber stamps, or print an image on PNP film using a laser printer.Bend bracelet, following instructions included with EZ-Bender. To finish shaping the ends, bracelet may need …
May 27th 2021 Summer Melaas
Copper Sands Earrings Tutorial

Copper Sands Earrings Tutorial

Created by: Tiffany White Designer TipsOne meter of this chain will make approximately 9-10 pairs of earrings!Place all the crystals onto the head pins and secure with wrapped loops. (New to jewelry-making? See Basic Jewelry-Making Technique Sheet PDF.)Arrange the crystal dangle colors randomly and attach two dangles per link of chain, using 3mm jump rings.The original project used a combination of 3 and 4mm crystal bicones in shades of copper and topaz, but now we have very few 3mm bicones …
Jan 1st 2021 Tiffany White
99 Luftballons Tutorial

99 Luftballons Tutorial

ok, so maybe it's just 2 Red Balloons, not 99...Created by: Summer Melaas and Polly Nobbs-LaRue   Designer TipsPunch a 1/16" hole in each blank, directly opposite the existing loop or hole.Clean the blanks with Penny Brite to remove all oils.Spray each blank lightly with Klyr Fire before sifting enamel evenly onto each blank: red on the balloons, and foundation white on the strips.Carefully transfer a blank to torching basket (in tripod, over a heat-resistant work surface), and torch fire. …
Jan 1st 2021 Polly Nobbs-LaRue