Rings & Things Jewelry Blog

Created by: Mollie ValenteDesigner TipsPlace a Swarovski square cushion stone in the bezel setting. Firmly hold the bezel setting (or work on a rubber block). Use the burnisher to carefully push the first bezel prong until it is set against the stone. Rotate the bezel setting so the second prong you set is opposite the first one. Then set the final two prongs in the same manner. Repeat these steps with the second stone and setting.The jump ring serves as a connector between the heart charm and t …

Created by: Summer MelaasDesigner TipsPlace 10mm cushion square stone into setting, and use nylon-jaw or chain-nose pliers to gently flatten the prongs onto the stone. See tips in our blog, for best way to keep your stone safe and centered.Carefully add bail to top of pendant (gently open the prongs with needle-nose pliers if needed). Use nylon-jaw or chain-nose pliers to securely close the bail.One loop on the setting is openable. Twist the loop open far enough to add the bail, then twist to se …

Created by: Veronica GreenwoodDesigner TipsPlace the crystal in the bezel setting and using the nylon jaw flat pliers gently fold the prongs down over the crystal.Using the 6.5mm jump ring attach the bezel to the large round link. (For best way to open and close loops, see Jump Ring Hint in Jewelry Basics 101).Attach one of the 5mm jump rings to the large round link.Use the second 5mm jump ring to attach the earwire to the first 5mm jump ring.Repeat for the other earring.Suggested Supplies2 each …

Created by: Veronica GreenwoodDesigner TipsPlace 12mm rivoli in bezel setting and gently bend prongs over crystal using needle nose pliers.With a piece of 24-gauge wire, make a wrapped loop making sure the loop is large enough to slide on to the leather (see Jewelry Basics 101 PDF).Add an 8mm pearl and link the other end to one side of the bezel.Using a 6mm jump ring, attach the princess cut crystal to the bottom loop of the bezel.Cut desired length of leather cord.Attach one center-crimp leathe …