Rings & Things Jewelry Blog

Created by: Sondra Barrington Designer TipsKeep gold-filled and gold-plated findings separate, and mark your supplies well!Use chain-nose pliers to turn the loop on ear wire 90-degrees so it faces side to side (not front to back). This is easier to do, before you assemble the rest of the earring components.Wire-wrap the dangles directly on loop. New to jewelry-making? See Basic Jewelry-Making Technique Sheet (PDF) for step-by-step looping instructions. Suggested Supplies1&nbs …

Learn to make these sweet gold-filled chain tassel and link/hoop earrings, featuring Swarovski Edelweiss pendants, with parts that have been tested to work together!Created by: Tiffany WhiteDesigner TipsFor best way to open and close jump rings, and step-by-step instructions on making wire wrapped loops, see Jewelry Basics 101 (PDF).Attach one of the larger gold-filled jump rings to a Swarovski edelweiss pendant, and attach to a textured gold-filled link. Use another one of the larger gold-fille …

Created by: Laurel NewnhamDesigner TipsCut wire into two 16" lengths, one for each earring. Trim excess as needed.Hold wire tightly to create loops that are closer together.Experiment with the position of the beads if using other shapes such as bicones, firepolish rounds or tiny cubes. Some shapes are easier to add on the outer rim of the ring, than others.Free Technique Sheets & How-TosBasic Jewelry-Making Technique Sheet (PDF)Blog post: Wire lashing: an easy way to cover your jewelry with …

Created by: Mollie ValenteDesigner TipsPlace a Swarovski square cushion stone in the bezel setting. Firmly hold the bezel setting (or work on a rubber block). Use the burnisher to carefully push the first bezel prong until it is set against the stone. Rotate the bezel setting so the second prong you set is opposite the first one. Then set the final two prongs in the same manner. Repeat these steps with the second stone and setting.The jump ring serves as a connector between the heart charm and t …

Created by: Mollie ValenteDesigner TipsCut the wire in half and form an "eye" loop on one end of each wire.Flatten the loop by striking with a chasing hammer on a steel block.Add the following beads to each handmade eye pin: a brass heishi, a crystal rondelle, and a brass heishi.For each bead link, cut off the excess wire leaving just enough length to form a second eye; form the eye and flatten the loop.Punch a hole centered in the top side of the triangle.Twist open the eye of the eye pin, add …