Rings & Things Jewelry Blog

Created by: Rita Hutchinson Designer Tips Cut your metal sheet to desired size and use a file to round the corners and smooth all edges.Clean with Penny Brite® Copper Cleaner and scrubby until water sheets off. Only handle by the edges from this point on.Stamp your design once, cleanly, and lift the stamp straight off. Allow the ink to dry without disturbing further. If needed or desired, touch up the inked design with black or red Sharpie® marker.Etch as directed following instruction …

Created by: Summer MelaasDesigner TipsEtch earrings (See etching tutorial below).Place cushion in cushion setting and fold over tabs using nylon-jaw pliers or a burnisher.Attach French hooks to top of cushion.For best way to open and close loops, see Jump Ring Hint in Jewelry Basics 101 (PDF)Attach etched copper drop to bottom of cushion.Suggested Supplies1 pair #34-003-8 TierraCast Earring Hook Findings, Niobium - Bronze and Copper Color2 each #41-878-51-10-7 Antiqued Copper Plated 2-Loop Bezel …

Created by: Amy MickelsonDesigner TipsPostage stamp charmThe canceled postage stamp was scanned and reduced to fit the square picture-frame charm.Seal front and back of the image with a waterproof barrier before applying the Magic-Glos™ resin. Use clear packing tape, transparent shelf liner, laminating film or a coating of liquid polymer clay. Do not use a water-soluble sealer like decoupage fluid or Mod Podge®.Burnish around the the edges to make sure the image is sealed completely.Use a small …

Created by: Polly Nobbs-LaRue Designer TipsThe original alligator clip used for this barrette is no longer available, but our new French-style barrette backs are more secure (hold better in hair) and now have a good hole for riveting.A fine-point Sharpie is about the perfect minimum width for etched designs with ferric chloride.With the fine-point Sharpie, draw a line about 90mm from the end of the copper strip. (About 5mm or 1/4" longer than the barrette back). Sketch your rough design, keeping …