Rings & Things Jewelry Blog

Created by: Cindy MorrisDesigner TipsString necklace and finish ends following directions in Beading Cable How-To Sheet below. Use Wire Guardians for a professional finish at the ends of your beading cable.When using soft solder, you can use either a soldering iron, or a gentle touch with a butane micro torch.It's important to use separate firing surfaces for soft solder and silver or copper solder. Do not use the same firing brick for both.For the pendant, melt soft solder onto the ba …

Created by: Cindy Morris Designer TipsClose the hoop. Lash the rhinestone chain onto the hoop using Artistic Wire, wrapping around the hoop twice between each link of chain.Start and end the chain over the opening of the (now closed) hoop. Trim ends when done.The last link on each end will not lie quite flat, so tie the lark’s head knot over this spot to hide them.Make sure your cord lengths are equal before attaching cord ends and clasp.Free Technique Sheets & How-TosBasic Jewelry-Maki …

This project uses Swarovski crystal pearls. Created by: Cindy MorrisDesigner TipsSince you only need to make simple loops and open/close jump rings, these earrings are a perfect project to make on the run with a mini tool kit!Add a 10mm round lapis, sodalite, or blue crystal pearl bead to an eye pin, then 3 metal spacer beads. Make a simple loop. Use a small jump ring to attach this drop to the bottom loop of an ear wire.Use a larger jump ring to attach the bone leaf charm to the bottom. If your …