13 results for '39-343-7'

News & Information (13)

Pearls Before Swine Necklace Tutorial(Post)

Created by: Mollie ValenteDesigner TipsCreate a saddle for the pig with two filigrees wrapped around his middle.Use jump rings to connect the two filigrees at the top. Carefully bend the filigrees ar ...

Dzi Fishing Hook Necklace Tutorial(Post)

Created by: Megan Holden Designer TipsUse beading board or beading mat to arrange beads in pattern as shown in picture.String 10 seed beads onto a 20"" piece of beading cable and then building u ...

Noble Fir Necklace Tutorial(Post)

Created by: Mollie ValenteDesigner TipsCreate a COPPRclay™ pendant following the manufacturer's guidelines included with the clay and your kiln.Mollie made her own pattern sheet by taking a piece of ...

Impression COPPRclay Bracelet Tutorial(Post)

Created by: Sondra BarringtonDesigner TipsCreate the COPPRclay links according to the manufacturer's instructions. Like most other metal clays, COPPRclay must be fired in a kiln. COPPRclay shrinks ap ...

Pretty in Pink Bracelet Tutorial(Post)

Created by: The Swarovski Design Team Designer TipsFor best way to open and close loops, see Jump Ring Hint in Jewelry Basics 101 (PDF). Suggested Supplies1 6-pack #02-088-34-182  ...

Mehandi Coil Bracelet Tutorial(Post)

Created by: Rita HutchinsonDesigner TipsUse shears to cut flat wire. Texture as desired with texturing hammer or metal stamps.Create coil by wrapping at an angle around large barrel of bail making pl ...

Sand and Sea Gemstone Jewelry Tutorial(Post)

This simple strung jewelry design can be worn as a necklace or a wrap bracelet. Bead Stoppers make it easy to test the length of your finished design before crimping ends.Created by: Veronica Greenwo ...

Love Lifted Me - Bracelet Tutorial(Post)

Supplies listed will make a 7"" bracelet from end to end.Created by: the Swarovski Create Your Style Design TeamDesigner TipsAttach an approximately 5mm jump ring to the Spiral Heart charm and set as ...

Astral Love Resin Necklace Tutorial(Post)

Created by: Rita HutchinsonDesigner TipsSee instruction page for making no-solder bezels.Cut paper to match bezel wire shape.Seal paper and adhere to inside of bezel.Mix a small batch of resin and po ...

Gianni's Garden Necklace Tutorial(Post)

Created by: Mollie ValenteDesigner TipsMeasure, mark and punch the hanging holes: 3 holes spaced to match the loops of the triangle, and one hole on the bottom.Use a rubber stamp of your choice and t ...

Sunset Ombre Necklace Tutorial(Post)

This necklace project uses Kato PolyClay™ to create a pretty ombre effect that's easy to display on cable chain, or another jewelry chain of your choice.Created by: Tiffany White Designer Tips&n ...

Dark Skies Enameled Pendant Tutorial(Post)

Created by: Rita HutchinsonDesigner TipsUse dapping block to shape blank.After dapping, punch 1/16" hole using the smaller (silver) side of a EuroTool "helicopter" punch.Clean blank with penny brite ...

Delightfully Dotty Enameled Necklace Tutorial(Post)

Created by: Rita HutchinsonDesigner TipsCut copper sheet to size or use a premade copper blank. If you have cut your own blank, punch hole in appropriate location and file edges to remove roughness.C ...