13 results for '44-125-9'

News & Information (13)

Baptized by Fire Bracelet Tutorial(Post)

Created by: Lindsey GreenDesigner TipsMix and match the crosses in any way you would like! No pattern is required.Adjust the length of the leather pieces and number of jump rings to change the size of

Emma Dog Tag Tutorial(Post)

Emma is in our warehouse daily, and I wanted to honor her with some Jewelry.Created by: Rita HutchinsonDesigner TipsNew to stamping? See Metal Stamping 101.The 3mm Bridgette stamp set allowed a long p

Page 394 Bookmark Tutorial(Post)

"Turn to Page 394" is a quote known to most Harry Potter fans. What will you put on your custom bookmarks?Created by: Rita HutchinsonDesigner TipsThe stamp guides are tremendously helpful for keeping

Palomita Wrapped Leather Bracelet Tutorial(Post)

Created by: Polly Nobbs-LaRueDesigner TipsCast silver star beads and Bali-style flower beads make wonderful riveted accents. If a bead's hole isn't quite large enough, center the bead on the 1/16" cut

Red Bird Enameled Earrings Tutorial(Post)

Created by: Rita HutchinsonDesigner TipsPosition and emboss pattern on blanks with the Big Shot Jewelry Studio and embossing die. (See Big Shot Embossing blog article)Counter-enamel the blank (fire th

It's Good to Be King Tie Bar Tutorial(Post)

Created by: Mollie ValenteDesigner TipsCut the copper strip to about 2" in length. Use a texture hammer or pattern stamp to apply a random pattern. File the corners and sides until smooth.Soft solder

Tri-Tone Cuff Bracelet Tutorial(Post)

Created by: Rita Hutchinson   Designer TipsUsing a pre-cut and finished bracelet blank, and precut 6" patterned wire makes this bracelet assemble in a snap!Apply pattern to copper blank with desired m

The North Star Necklace Tutorial(Post)

Created by: Mollie ValenteDesigner TipsCreate a bail using a 5/16" x 3" piece of 24-gauge copper sheet: Cut, file, stamp, punch and ream the holes a bit larger. Use bail-making pliers to bend the stam

Safe Journey Pendant Tutorial(Post)

Created by: Mollie Valente   Designer TipsTo add texture, place the metal blank on the steel block and use the ball end of the hammer to make a lightly hammered surface.After hammering, the metal blan

Night Reflections Enamel Earrings Tutorial(Post)

Created by: Summer MelaasDesigner TipsUse the smaller end of the 2-hole metal punch to punch a 1/16" hole near the top of the blanks. Be sure to center it, so the earrings hang properly.Clean the blan

Pop of Color Enamel Earrings Tutorial(Post)

Created by: Summer MelaasNote: We've had great success enameling our 24-gauge brass blanks, but for the most consistent color results, this enamel is best with copper blanks. Designer TipsTexture the

Pawrific Enamel Necklace Tutorial(Post)

Created by: Summer MelaasDesigner TipsPunch a hole in the top corners of your copper blank. File any sharp bits.Clean your blank very well with warm water and Penny Brite.Cut your 22 ga bare copper wi

Avocado Dorado Cuff Bracelet Tutorial(Post)

Created by: Polly Nobbs-LaRueDesigner TipsSolder Brass Ninja Star* to Copper Disk:If the copper or brass shapes are bent, straighten them with a steel block and nylon or rawhide mallet. (Solder doesn'